Mts 318 Load Unit Manuel d'utilisateur télécharger pdf (Page 105)

Routine Maintenance Overview Checklist

318 Load Unit Maintenance

105

G. Using the offset wrench, loosen (but do not remove) the self-locking

nut.

Mechanical Null Adjustor Pin

H. Turn the adjustor pin until the scribe mark on the adjustor pin is

pointing toward the base of the servovalve.

I. Tighten the self-locking nut until 1.13 to 1.36 N·m (10 to 12 lb-in) of

torque is needed to turn the adjustor pin, ensuring that the scribe mark

remains pointing toward the base of the servovalve.

J. Remove the torque wrench and offset wrench.

4. Finish the procedure.

A. Ensure that the actuator is warmed up. If not, go to Step 1.

B. Remove hydraulic and electric power from the system.

C. Reconnect the servovalve cable.

D. Reapply hydraulic and electric power to the system.

E. See your controller manual to complete the valve balance procedure.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 119 120

Pas de commentaire

Mts 318 Load Unit Manuel d'utilisateur Page 105