Mts Hand-Operated Hydraulic Pump Manuel d'utilisateur télécharger pdf (Page 5)

Hand-Operated Hydraulic Pump

A hand-operated hydraulic pump kit (MTS part number 100-254-832) is an

accessory for operating the grips. The kit includes the pump, with shut-off and

release valves, a pressure gage, and hydraulic hoses for connecting the pump to

the grips. The kit also contains an extra supply of hydraulic fluid. An appropriate

grip supply with good pressure stability is required to safely operate hydraulic

grips.

Install the Hand-Operated Hydraulic Pump

The pump can be mounted to the base of the load frame with the provided

brackets and magnets. If you have a load frame that does not accommodate base

mounting, the hand pump can be placed on the floor near the load frame. It

includes two hydraulic hoses; one is 1829 mm (72 in) long; and the other is 2286

mm (90 in.) long.

Typical Grip Installation

The hand pump is provided with a plate including the hardware to mount the

hand pump to the side of any MTS Landmark load frame. When space permits,

the hand-operated hydraulic pump can be mounted to the sheet metal base of the

load unit. If not, other mounting arrangements will need to be devised. As a

minimum, mount the pump on a board or on an adjacent tabletop.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Pas de commentaire

Mts Hand-Operated Hydraulic Pump Manuel d'utilisateur Page 5