Mts Series 505G2 SilentFlo Hydraulic Power Unit Model Manuel d'utilisateur télécharger pdf (Page 64)

Model 505G2.07/.11 SilentFlo™ HPU

High Pressure Filter Kit

3. Connect the elbow to the input of the filter assembly. Connect the straight

tube to the output of the filter assembly.

High Pressure Filter Components

4. Connect the elbow of the filter assembly to the high pressure port on the

manifold assembly.

5. Connect the high pressure hose between the filter assembly and the high

pressure output port.

6. Turn on the hydraulic pressure and check for leaks.

Replacing the Filter

Element

The high pressure filter should be changed every 1000 hours or six months, or

when the Dirty Filter indicator is lit. You will need a filter element (MTS part

number 100-030-007) or a filter kit (MTS part number 100-030-194).

To replace the filter:

1. Ensure that system hydraulic pressure has been reduced to zero before

proceeding. To do this, turn off the hydraulic power unit and exercise the

actuator until it stops moving.

2. Unscrew the filter bowl and remove the filter element.

3. Lift the filter element out of the filter bowl. Be careful to catch any

hydraulic fluid dripping from the filter element with a rag or drip pan.

4. Insert the replacement filter into the filter assembly.

High

Pressure

Port

Elbow

High

Pressure

Hose

High

Pressure

Output Port

Control Manifold

Filter

Assembly

Check Valve

Free

Flow

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 85 86

Pas de commentaire

Mts Series 505G2 SilentFlo Hydraulic Power Unit Model Manuel d'utilisateur Page 64