Mts TestLine Manuel d'utilisateur télécharger pdf (Page 94)

Set up a Scope to compare the command signal to the resulting feedback. Enlarge the scope if

necessary, and then set up the scope as follows:

Y1 parameters:

• Channel — Ch1 (or other depending on your configuration)

• Signal — Command

• Unit — kN

• Units/div — 0.1000

• Offset — 0.3000

Y2 parameters:

• Channel — Ch1 (or other depending on your configuration)

• Signal — Force

• Unit — kN

• Units/div — 0.1000

• Offset — 0.3000

Time:

• Trace Time — 5.0000 s

5. Set the HPU and HSM to Power High.

94 | MTS TestLine Test System Operation

Running the Example HCF Test

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 131 132

Pas de commentaire

Mts TestLine Manuel d'utilisateur Page 94