Mts 316 Load Frame Manuel d'utilisateur télécharger pdf (Page 39)

Unpacking and Inspection

Series 316 Load Frame Product Information Installation

Installation

This section provides installation instructions for Series 316 Load Frame. MTS

System Corporation recommends that the procedures in the following

subsections be performed in the order given or referenced to minimize the chance

of damage to equipment or injury to personnel.

Unpacking and Inspection

Unpacking Load

Frame

If the load frame is shipped in the horizontal position strapped to a wooden skid,

it should be uncrated and tipped to its upright position before it is moved. Use

the following procedure:

1. Carefully cut and remove the strap form around the load frame using an

appropriate tool. Some load frames are bolted to the skid. Remove these

bolts if applicable.

2. Series 316 load Frames are shipped with eye bolts installed in the holes in

the top of the crosshead.

A. Attach lifting chain hooks (or equivalent) to all lift point eyebolts or

hoist rings. Ensure chain hooks are secure and of sufficient capacity

for the task (see “Specification” on page 9 for the weight of frame.)

B. Block the bottom of the load frame to prevent slipping as the load

frame is raised.

C. Slowly lift load frame to vertical position.

Unpacking Direct

Shear

1. Remove direct shear assembly with guide rails from crate.

2. Carefully cut and remove holding straps to direct shear assembly.

Inspection Inspect the load frame for evidence of structural damage. Inspect any electrical

connectors mounted on the load frame base for damage and cleanliness. If

shipped with hydraulic hoses attached, inspect the hose for evidence of damage

and leakage. Inspect the hose connections fitting for damage.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Mts 316 Load Frame Manuel d'utilisateur Page 39