Mts 316 Load Frame Manuel d'utilisateur télécharger pdf (Page 40)

Series 316 Load Frame Product Information

Lifting and Moving Instructions

Installation

Lifting and Moving Instructions

This subsection provides a procedure for lifting and moving the load frame.

Improper lifting or transportation of the device can result in damage to

equipment or injury to personnel.

Read and comply with the following instructions and refer to the Lifting and

Moving Instructions booklet attached to the load frame.

1. Ensure all devices involved in lifting and moving the load frame are in good

working order. Inspect eyebolts or hoist rings, chains, overhead crane, etc,

for cracks and damage. Replace as necessary.

2. Ensure all devices involved in lifting and moving the load frame can support

the weight of the load frame. (This weigh includes the load frame, load cell,

actuator, servo valve(s), manifold(s) grips, etc.)

3. The load frame must be lifted at the designated lift points only. The lift

points are locate on top of the crosshead.

4. If chains will be used to lift and move the load frame, the lifting chains must

not exceed a 30-degree angle from vertical to prevent undesired stress/strain

on the eyebolts or hoist rings.

5. Do not apply shock loads when lifting or moving the load frame. Shock

loads can cause momentary forces exceeding the actual load frame weight,

which can result in exceeding the recommended force rating of the lifting

devices.

6. Before lifting or moving the load frame, ensure all lifting chain hooks (or

equivalent are securely placed in all lift point eyebolts or hoist rings.

7. Lift load frame only has high as necessary. It is recommended to lift the

load frame only a few inches off the ground.

8. Move load frame to desire location and carefully lower into position

WARNING

1 2 ... 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Mts 316 Load Frame Manuel d'utilisateur Page 40