Mts 709 Alignment System Manuel d'utilisateur télécharger pdf (Page 95)

709 Alignment System Align

Plot Bending In this section you can select the plot to be in Strain values or Percent. The Auto

Scale feature, when checked, will automatically scale the graph on the right of

this tab as the points representing the load values of the three gauges approach

the target microstrain.

If Auto Scale is not checked you can set the full scale range on the graph using

the Set button. or set the graph to optimum scale using the Reset button.

Specimen Offsets Clicking this button will bring up the specimen offsets window. See “Specimen

Offsets” on page 83 for additional information.

Use Offset In this section you select the offset for compensating the displayed values. None

for no offset, just the raw reading. Specimen Gauge or Specimen Bent offset

from the specimen offset procedure. Or Current Tare, which uses the current

reading to zero out the values.

Alignment Wizard Pressing this button brings up the alignment wizard to aid in alignment

adjustments. See “Alignment Wizard” on page 97 for additional information.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 157 158

Pas de commentaire

Mts 709 Alignment System Manuel d'utilisateur Page 95