Mts ReNew Technical Reference Manuel d'utilisateur télécharger pdf (Page 26)

ReNew Technical Reference

Installation

Installing cables

Exercise care when connecting cables. Ensure that you are using the correct

cables and that all connections are secure. When you are finished, double-check

to ensure that all components are connected properly.

Turn the power off before connecting cables.

Connecting cables with power applied can cause damage to the equipment.

Basic controller connectors

J1—USB. This is the connection to the computer.

J2—Handset. This is intended for a handset.

J3—Interlock. This is intended to connect to a test area enclosure switch that

opens when the door is opened. If not used a jumper plug must be installed.

J4—Encoder. This is intended for an encoder based long stroke extensometer.

J5—Digital I/O. Includes (3) optically isolated inputs, (3) optically isolated

outputs and 12V power. Functions of each digital input or output are intended to

be software selectable. Refer to the TestWorks manual for what signals can be

selected.

J6—Monitor 2. BNC output. Intended to be software selectable analog output

with +/-10V full scale. Refer to the TestWorks manual for what signals can be

selected.

J7—Monitor 1. BNC output. Intended to be software selectable analog output

with +/-10V full scale. Refer to the TestWorks manual for what signals can be

selected.

CAUTION

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 49 50

Pas de commentaire

Mts ReNew Technical Reference Manuel d'utilisateur Page 26