Mts SWIFT 50 GLP Sensor Manuel d'utilisateur télécharger pdf (Page 22)

SWIFT 50 GLP Sensors Installation

Coordinate System

Hardware Overview

The SWIFT coordinate system is transducer-based, with the origin located at the

center of the transducer. Positive loads are defined as applied to the outer ring of

the transducer.

• Vertical force (Fz) is positive up

• Lateral force (Fy) is positive out of the vehicle

• Longitudinal force (Fx) is positive out of the transducer

You can change to the MTS Model 329 Road Simulator convention (lateral load

into the vehicle is always positive) or to any coordinate system by changing the

polarities in the calibration file. For instructions on how to change the coordinate

system polarities, see “Setting up the Transducer Interface” in the SWIFT 50

GLP Sensor Product Information manual (MTS part number 100-162-722).

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 69 70

Pas de commentaire

Mts SWIFT 50 GLP Sensor Manuel d'utilisateur Page 22