Mts Hand-Operated Hydraulic Pump Manuel d'utilisateur

be certain.mProduct InformationHand-Operated Hydraulic Pump100-297-631 A

Hand-Operated Hydraulic Pump10Install Specimen in the GripsPerform the following procedure to mount a specimen in the grips. Ensure that all grip part

Hand-Operated Hydraulic Pump11MaintenanceMaintenance for the hydraulic hand pump involves checking the fluid level in the reservoir of the hand pump o

Hand-Operated Hydraulic Pump12

mMTS Systems Corporation14000 Technology DriveEden Prairie, Minnesota 55344-2290 USAToll Free Phone: 800-328-2255 (within the U.S. or Canada)Phone: 95

Copyright information © 2014 MTS Systems Corporation. All rights reserved.Trademark information MTS is a registered trademark of MTS Systems Corporati

Hand-Operated Hydraulic Pump3ContentsInstall the Hand-Operated Hydraulic Pump 5Determine the Gripping Pressure 7Install Specimen in the Grips 10Remove

Hand-Operated Hydraulic Pump4

Hand-Operated Hydraulic Pump5Hand-Operated Hydraulic PumpA hand-operated hydraulic pump kit (MTS part number 100-254-832) is an accessory for operatin

Hand-Operated Hydraulic Pump6Note In order for the pump to operate, the reservoir end of the pump assembly must be higher than the output end (or at l

Hand-Operated Hydraulic Pump7D. Apply sufficient pressure to the grips and check for leaks at all fittings. Sufficient pressure will be determined by

Hand-Operated Hydraulic Pump8Force versustemperatureThe following figure shows that the grip force rating for specimen temperatures up to 700°C is 67

Hand-Operated Hydraulic Pump9Required Pressure for the Applied Force