Mts SWIFT 20 Ultra Sensor Manuel d'utilisateur télécharger pdf (Page 73)

SWIFT 20 Sensors Installing the Transducer

Installing the Transducer

Important This section includes information related to the Low-Profile

Transducer Interface (TI). For SWIFT transducers designed to

operate with the newer Mini TI, there is a separate manual that

documents the transducer installation with the Mini TI (MTS part

number 100214316).

The SWIFT sensor can be installed on a vehicle at the test track or on an MTS

Series 329 Road Simulator in the test laboratory.

Contents Test Track Vehicle for Slip Ring Sensor 74

Attaching SWIFT Components to the Wheel Assembly 77

Attaching SWIFT and Wheel Assembly to the Vehicle 80

Installing the Low-Profile Transducer Interface Electronics 82

Setting up the SWIFT Sensor for Data Collection 85

Verifying the Quality of the Zero Procedure 95

Collecting Data 98

Road Simulator 100

Attaching SWIFT Components to the Fixturing 102

Zeroing the Low-Profile Transducer Interface 105

Communication Configurations 106

Cable Configurations 108

Transducers Designed to Operate with a Low-Profile TI but Using a Mini TI

For SWIFT transducers designed to operate with a Low-Profile but are using the

Mini TI, an adapter cable is needed; MTS part number 100224052. The

transducer and shunt cables are connected to one end of the adapter cable and the

other end is connected to J3 of the Mini TI.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 175 176

Pas de commentaire

Mts SWIFT 20 Ultra Sensor Manuel d'utilisateur Page 73