Mts SWIFT 30 Sensor Manuel d'utilisateur télécharger pdf (Page 76)

SWIFT 30 Sensors

Test Track Vehicle

Installing the Transducer

Do not use high-pressure-air to clean debris from around the transducer

connectors.

High-pressure-air can damage the silastic seals.

Use a fine wire brush and low air-pressure [0.07 MPa (10 psi)] to clean debris

from around the transducer connectors.

Do not lay the wheel flat while the transducer is attached to it.

When the wheel is laid flat with the transducer facing down the weight of the

wheel can damage the connectors.

Always hold the wheel upright when the transducer is attached to it. If needed,

have another person hold the tire upright while you tighten the bolts, or place the

wheel on a thin layer of foam to protect the connectors.

Do not under-torque the lug nuts.

Lug nuts that are not properly tightened can become loose during testing.

Loss of a wheel can cause damage to the test vehicle and transducer and

result in injury to personnel.

Always tighten the lug nuts to the torque rating recommended for the vehicle/

wheel.

Do not drop the slip ring bracket (spider).

Dropping the slip ring bracket can damage the slip ring or a connector.

Always use care when you handle the slip ring bracket.

CAUTION

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 171 172

Pas de commentaire

Mts SWIFT 30 Sensor Manuel d'utilisateur Page 76