Mts Fatigue Template Manuel d'utilisateur télécharger pdf (Page 81)

DescriptionItem

Specify a number of cycles for the maximum length

of the test.

Total Cycles

9.2.3.0 Data Storage Parameters

Data Storage Parameters Properties

DescriptionItem

Sets the number of cycles to save to disk at the end

of the test or when the test stops.

Ending Cycles

Sets the amount of change that must occur in the

maximum load between saves to disk.

Load Storage

Change

Sets the value of N, which is the rate (number) of

peak-valley cycles for a store to disk to occur. For

PV Nth Cycle

Stored

example, if this parameter is 100, data is saved to

disk every 100 cycles.

Sets the number of cycles to save to disk at the

beginning of the test or when the test is started.

Starting Cycles

Sets the number of cycles of time data per decade

based on a logarithm to save to disk.

Time Cycles Per

Log Decade

Stored

Sets the number of levels between saves to disk.Number of Levels

Sets the range the data must exceed to detect the

peak-valley data. Within this range, points are

considered noise and not peak or valley data.

Strain Noise Band

Percent

Sets the amount of change that must occur in the

displacement between saves to disk.

Displacement

Storage Change

9.2.4.0 Transition Parameters

Transition parameters include:

• Inelastic Strain Transition Limit

• Test Time Limit

• Transition Maximum Stress Percent Change

• Transition Monitoring Minutes

• Transition Stress-A Ratio Percent

MTS TestSuite 81

9.0 Transition Test Elevated Temperature Template

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 121 122

Commentaires sur ces manuels

Pas de commentaire

Mts Fatigue Template Manuel d'utilisateur Page 81

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Mts Fatigue Template