Mts SWIFT 10 MC Sensor Manuel d'utilisateur télécharger pdf (Page 82)

SWIFT 10 MC Sensors

Road Simulator

Installing the Transducer

Do not use high-pressure air to clean debris from around the transducer

connectors.

High-pressure air can damage the silastic seals and may void the warranty.

Use a brush with fine, non-metal bristles and low air-pressure [0.07 MPa (10 psi)]

to clean debris from around the transducer connectors.

Do not under-torque the lug nuts.

Lug nuts that are not properly tightened can become loose during testing.

Loss of a wheel can cause damage to the test vehicle and transducer and

result in serious injury, death, or property damage.

Always tighten the lug nuts to the torque rating recommended for the vehicle/

wheel. Recheck the torque daily and/or before each testing session.

CAUTION

WARNING

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 143 144

Pas de commentaire

Mts SWIFT 10 MC Sensor Manuel d'utilisateur Page 82