Mts SWIFT 10 MC Sensor Manuel d'utilisateur télécharger pdf (Page 94)

SWIFT 10 MC Sensors

Zeroing the Transducer Interface

Installing the Transducer

Note When the square head setscrew on the slip ring/encoder is aligned

opposite the center of the flat on the axle spacer (between the mounting

screws on the anti-rotate bracket when it is installed) the index mark is

under the encoder sensor.

2. Rotate the adapter plate, as necessary, until the Fz on the axes icon (see the

next figure) printed on the transducer label is pointing up. If the icon is not

visible use the mark placed on the adapter plate during installation for

orientation.

3. Hold the inclinometer against a flat on the hub adapter at 90° from the

connector brackets (see the next figure).

4. Adjust the adapter plate, as necessary, until the inclinometer reads 45.0°,

±0.1° when oriented as shown in next figure.

Example Inclinometer Mounting Locations

(shown with transducer removed for clarity)

Axes Icon

S10MC-22

Example Inclinometer

Mounting Locations

Connector

Brackets

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 143 144

Pas de commentaire

Mts SWIFT 10 MC Sensor Manuel d'utilisateur Page 94