Mts Series 505G2 SilentFlo Hydraulic Power Unit Model Manuel d'utilisateur télécharger pdf (Page 65)

Surge Suppressor Kit

Model 505G2.07/.11 SilentFlo™ HPU

5. Screw the filter bowl back onto the filter assembly. Torque the filter bowl to

27.1 N•m (20 lbf-ft).

6. Press the Reset button on the HPU control panel to reset any interlocks and

turn off the Dirty Filter indicator.

Surge Suppressor Kit

The surge suppressor kit smooths out the ripple caused by the pulsing action of

the pump as it pressurizes the hydraulic fluid. The surge suppressor is a cylinder

that has an outer sleeve that is pressurized with nitrogen. The gas pressurized

sleeve dampens the pressure pulses.

The surge suppressor is mounted to the output of the hydraulic pump inside the

reservoir.

Required equipment You will need the following to install the Surge Supressor kit:

• A Model 505.07 Surge Suppressor kit (part number 100-008-667) or a

Model 505.11 Surge Suppressor kit (part number 100-008-665).

• Optional Remote Charging kit (part number 100-056-912)

• A transfer pump with a 10-micron filter (such as the Model 590.01 Fluid

Transfer Pump).

• A cleaning solvent such as ethanol.

• A charging kit (part number 037-698-601).

Installation procedure To install the Surge Suppressor Kit.

Remote Charging adapter

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 85 86

Pas de commentaire

Mts Series 505G2 SilentFlo Hydraulic Power Unit Model Manuel d'utilisateur Page 65