Mts SWIFT 45 GLP Sensor Manuel d'utilisateur télécharger pdf (Page 23)

Coordinate System

SWIFT

45 GLP Sensors

Hardware Overview

The SWIFT coordinate system is transducer-based, with the origin located at the

center of the transducer. Positive loads are defined as applied to the outer ring of

the transducer.

• Vertical force (Fz) is positive up

• Lateral force (Fy) is positive out of the vehicle

• Longitudinal force (Fx) is positive out of the transducer

You can change to the MTS Model 329 Road Simulator convention (lateral load

into the vehicle is always positive) or to any coordinate system by changing the

polarities in the calibration file. For instructions on how to change the coordinate

system polarities, see the chapter, “Setting up the Transducer Interface”.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 105 106

Pas de commentaire

Mts SWIFT 45 GLP Sensor Manuel d'utilisateur Page 23