Mts SWIFT 45 GLP Sensor Manuel d'utilisateur télécharger pdf (Page 73)

SWIFT

45 GLP Sensors

Maintenance

Cables

Monthly Inspect all electrical cables monthly, or after every 160 hours of operation.

Always turn off the electrical power before you disconnect, repair, or replace a

cable.

1. Check the condition of the cables for cuts, exposed wires, or other types of

damage, loose connectors, and cracked or worn cable covers. Tighten any

loose connectors. Replace any cracked or worn cables.

2. Ensure that cable connectors are securely plugged into their respective

receptacles.

3. Ensure that all cables have appropriate strain relief devices installed.

4. Protect cables from being stepped on. In the test lab, elevate and cover all

cables to protect them from exposure to spilled hydraulic fluid.

5. Ensure that all cables are supported every 1.2 m (4 ft). Cables should also be

supported near a motion joint.

6. Check that path ways of moving cables are clear of obstructions. Prevent

cables from moving or rubbing against sharp corners.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 105 106

Pas de commentaire

Mts SWIFT 45 GLP Sensor Manuel d'utilisateur Page 73