Mts FlexTest Models 200 Manuel d'utilisateur télécharger pdf (Page 301)

Aero Multibox Overview

MTS FlexTest® Models 40/60/100/200 Controller Hardware Aero Multibox Systems

301

Multibox Processor Settings

When used in a multibox system, both processors in each box must have Switch

1 Bit 6 set to the off position.

Note If you remove a box from a multibox system and use it as a standalone

controller (without a Model 49x.43 Multibox board), you must set Switch

1 Bit 6 on both processor boards to the on position.

Typically, when a box is removed from a multibox system, the Model

49x.43 Multibox board remains in the box and Switch 1 Bit 6 on both

processor boards are left in the off position.

7100 Processors 7100 processors do not have multibox switch settings.

• When used in a multibox system, the processor IP address is determined by

the chassis address setting on the Model 49x.43 Multibox board.

• When used in a single-box configuration, the processor IP address defaults

to 148.150.203.191.

Multibox Systems:

Set Switch 1, Bit 6

to the OFF position

Single-box Systems:

If the single-box

system does not include

a Model 49x.43 board,

set Switch 1, Bit 6

to the ON position

If the single-box system

includes a

Model 49x.43 board,

you can leave

Switch 1, Bit 6 in the

OFF position.

Processor Board

1 2 ... 296 297 298 299 300 301 302 303 304 305 306 ... 343 344

Pas de commentaire

Mts FlexTest Models 200 Manuel d'utilisateur Page 301